Docker – Containers & Shells


Docker – Containers and Shells


”;


By default, when you launch a container, you will also use a shell command while launching the container as shown below. This is what we have seen in the earlier chapters when we were working with containers.

Shell Command

In the above screenshot, you can observe that we have issued the following command −

sudo docker run –it centos /bin/bash 

We used this command to create a new container and then used the Ctrl+P+Q command to exit out of the container. It ensures that the container still exists even after we exit from the container.

We can verify that the container still exists with the Docker ps command. If we had to exit out of the container directly, then the container itself would be destroyed.

Now there is an easier way to attach to containers and exit them cleanly without the need of destroying them. One way of achieving this is by using the nsenter command.

Before we run the nsenter command, you need to first install the nsenter image. It can be done by using the following command −

docker run --rm -v /usr/local/bin:/target jpetazzo/nsenter

Nsenter Image

Before we use the nsenter command, we need to get the Process ID of the container, because this is required by the nsenter command. We can get the Process ID via the Docker inspect command and filtering it via the Pid.

Inspect Command

As seen in the above screenshot, we have first used the docker ps command to see the running containers. We can see that there is one running container with the ID of ef42a4c5e663.

We then use the Docker inspect command to inspect the configuration of this container and then use the grep command to just filter the Process ID. And from the output, we can see that the Process ID is 2978.

Now that we have the process ID, we can proceed forward and use the nsenter command to attach to the Docker container.

nsenter

This method allows one to attach to a container without exiting the container.

Syntax

nsenter –m –u –n –p –i –t containerID command

Options

  • -u is used to mention the Uts namespace

  • -m is used to mention the mount namespace

  • -n is used to mention the network namespace

  • -p is used to mention the process namespace

  • -i s to make the container run in interactive mode.

  • -t is used to connect the I/O streams of the container to the host OS.

  • containerID − This is the ID of the container.

  • Command − This is the command to run within the container.

Return Value

None

Example

sudo nsenter –m –u –n –p –i –t 2978 /bin/bash

Output

Nsenter

From the output, we can observe the following points −

  • The prompt changes to the bash shell directly when we issue the nsenter command.

  • We then issue the exit command. Now normally if you did not use the nsenter command, the container would be destroyed. But you would notice that when we run the nsenter command, the container is still up and running.

Advertisements

”;

Leave a Reply

Your email address will not be published. Required fields are marked *